Chassis Upgrades

Tags: design, mechanical, and think
Personhours: 5
Chassis Upgrades By Austin

Task: Upgrade our chassis

Because our robot at this point has merely become a collage of prototypes that we compete with, there are often subtle improvements that need to be made. Starting with the wheelbase, Abhi has written a blog about the shields we printed to protect the glyphs from the gnashing bolts of our mechanum wheels, and we also tensioned all our set screws and motor mounts to make sure that our base was preforming in terms of the speed and strength we needed. As we add components to the robot things often are shifted around as well, after tuning up the drive train we focused on realigning our REV expansion hubs and their wiring so that nothing would be in the way of critical lift or drivetrain components.

Any jettisoning bolts that have been catching components while moving, and any sharp edges have all been ground down to ensure that any motion is smooth and that there are minimal catching hazards during operation. Because of the earlier mentioned prototype state our robot was in, many of the key components laid outside of the 18 inch cubic limits and so these components we brought in and neatly fastened to the internals of the robot bearing in mind ease of access for future updates to components. This entire push for cleanliness was the result of upcoming scrimmages and practice matches that we would be participating in.

Written on October 8, 2017